Interested from United States, OR Public Profile

Used this to attach my Primary Arms GLx 2x ACSS CQB Prism scope to the carry handle on my PSA Dissipator. It lets you still see the iron sights when installed. It also lets you choose two positions for the scope, centered or closer to you on the carry handle.

It’s a perfect contour to attach an ACOG style scope to your carry handle. If you got the Primary Arms GLx 2x Prism scope like I did though, it’s included and you don’t need to buy this. Optics Planet was good to accept my return. I bought the carry handle adapter as well because it is needed.

I got this to save battery life on five of my low power variable optics (lpvo). Perfect if you’ve ever left your battery switch on on accident. I’ve only bought two so far and they’re on my Primary Arms SLx 1-6 ACSS Raptor 1-6 FFP 7.62x39/300 blackout and my PA SLx 1-8 ACSS Raptor FFP 5.56/5.45/.308. It powers down after about two minutes with no movement. It shakes awake with a good tap. It adds about 1/4 inch to the width of the battery side of your scope. It has a locking ring to keep it tight and a tool included for that. Go to Primary Arms website to see a full list of optics for this item to work with. They show more Primary Arms lpvo optics, a Sig and Vortex as well. Buy it from here to get it discount code, and free shipping when you add enough to your cart.

A little bigger than a factory AK grip. Great rubber texture and close to a vertical angle. I like the storage compartment for my sbr and silencer paperwork. I have them now on my Micro Draco, PAP M92, Polish Underfolder, and WASR 10 that I sold. Just got another for my Mini Jack that I’m going to sbr. It also counts as one part for 922R compliance.

Pretty easy to install. Franklin Armory has a YouTube video to follow along with. Have super glue ready for hammering in the plugs to the holes. Mine popped out a few times before hitting them hard and square enough to get in. I needed to Dremel a small burr from my trigger guard rivets to get the trigger to sit flush. Ten seconds tops, careful not to do too much and touch the finish on your receiver. I didn’t need to adjust the adjustment screw to pass the function tests on the video. I trimmed the sticker to just show the bullets/function positions and it looks much better. Cyclic rate is fantastic! I have a AK Buff medium orange buffer in it that helps the recoil and might help increase the speed of cycling. Wish it had a normal looking AK safety lever to complete the look, but they probably had a reason not to do it. Check out my YouTube video “Binary Micro Draco SBR Dead Air Wolverine PBS-1” to see it suppressed and unsuppressed. Won’t work in my PAP M92 or Underfolder AK because of fit as stated by the manufacturer. Only works in stamped receivers too.